Aqua Sealer waterproofing 1L
Brand: Louis XIII - Avel
Moisture, dirt and various stains inevitably become embedded in the floor. The protection of the support with a product that respects its nature is essential.
26,14 € + VAT
The materials for floors are mostly porous. Humidity, dirt and various stains are inevitably embedded. Then it is essential to protect the support with a product that respects its nature.
Protective treatment: Its hydrophobic and oleophobic top-pore formula forms a film against stains of various nature. It is characterized by its extreme chemical resistance (fatty acid). "Aqua Sealer AVEL" consolidates the joints, preventing the formation of moss and offers excellent resistance to mechanical abrasion.
Decorative treatment: "Aqua Sealer AVEL" deposits on the surface a waxed patina of easy cleaning and maintenance without the need for another finish.
"Aqua Sealer AVEL" can be used as a primer before the application of a leveling paste or glues on absorbent supports.
According to the traffic, its duration against aggressions and chemical agents and U.V. It is 5-10 years old.
Interior: Especially adapted to porous floors: terracottas, paving stones, concretes, tiling, cement tiles, natural or reconstructed stones, marble, granite or stoneware.
Once the ground is protected, it will be able to resist any aggression without being altered.
INSTRUCTIONS FOR USE
Preparation of the support: "Aqua Sealer AVEL" must be applied on neutral, clean and perfectly dry Ph supports.
On old or already treated supports, it is necessary to strip the surface layer to allow the resin to penetrate. Eliminate all traces of organic waste with "Carrelax AVEL" and mineral waste with "Cimentax AVEL".
Any previous application of an acid or alkaline pickling product should be followed by an abundant rinsing and a sufficient drying time (1 week before applying the resin).
The use on wet substrates will cause the formation of aureoles of saltpeter on the surface of the material. Verify the complete drying of the support with the help of a moisture tester or by making a test by sealing a tile with a plastic film for 12 hours, to check that there is no moisture.
1. Apply 1 to 2 coats with an extender, a semi-long hair roller, a clean cloth or a sprayer. Wait for the first layer to dry before applying the second layer.
2. For the application on exterior surfaces and vertical walls, make sure that there are no water infiltrations due to overlapping, roofs, gutters ...